Bissell 1719, 1718 warranty Operations, Charging the battery, Filling the solution tank

Models: 1718 1719

1 12
Download 12 pages 35.33 Kb
Page 6
Image 6

Operations

Charging the battery

1.When charging for the first time, allow to charge uninterrupted for at least 12 hours.

NOTE: When charging, the Spot Lifter and charger may become warm to the touch. This is normal and no cause for concern.

2.Spot Lifter must be in “ O ” (OFF) position to charge.

3.When completely charged, your Spot Lifter

will operate for up to 7 minutes for model 1718 and up to 15 minutes for model 1719. When completely discharged, it will take approximately 12 hours to fully recharge.

4.To charge your Spot Lifter, connect the round end of the charger cord into the power port on the back of the unit.

NOTE: Decreased operating time may indicate that the battery has built up a charging resistance. To recharge, first completely exhaust the battery, recharge it, then exhaust it once again before recharging a second time. This procedure may be required more than once.

Tip:

For maximum battery life, completely discharge and recharge Spot Lifter every 1-2 months.

Tip:

After unit is charged (approximately 12 hours) unplug from outlet.

This will aid in prolonging the life of the battery.

1.

Filling the solution tank

1.Remove solution tank by grasping it firmly and pulling straight up.

2.Unscrew and remove the cap. Add water and formula* to the indicated fill lines on the solution tank.

*Note: Your Spot Lifter includes a trial size bottle of 2X formula.

3.Replace cap and place solution tank back on unit.

2.

Water Fill Line

WATER

FORMULA

Formula Fill Line

3.

66

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

Page 6
Image 6
Bissell 1719, 1718 warranty Operations, Charging the battery, Filling the solution tank