Bissell 1960 warranty Pre-Treating, Deep Cleaning

Pre-Treating

Pre-treat stubborn stains and highly soiled carpet in hallways and other high-traffic areas.

Tip:

1.

Spray soiled area with BISSELL® Tough Stain PreCleaner.™

Deep cleaning spots, spills and high traffic areas on a regular basis can

2.

Use a stiff-bristled brush to work formula into carpet pile.

prolong carpet life.

3.

Wait 3 -5 minutes before deep cleaning.

Deep Cleaning

Turn Power Switch [located on the side of the Lower

1. Body] to ( ) ON.

With foot, press the Detent Lever on right side of Lower Body.

2.

Depress Spray Trigger to spray cleaning solution.

3. Do not overwet.

To suction up water, repeat motion over same area without

4. depressing Trigger.

Tip:

It is recommended that every time your Clean Water Tank is emptied of solution that you empty the contents of the Dirty Water Tank. If the Dirty Water Tank gets too full, you may begin to see foam spitting out of the vent cover. When this happens you will know it is time to empty the

5.

6.

Repeat Steps 3 and 4 until no more dirt can be removed.

Continue to clean entire carpet, working in 3’ x 4’ sections.

Empty the Dirty Water Tank when dirty water reaches the

Dirty Water Tank.

7.	Vent
	Cover

7. full line, or when the Clean Water Tank is empty. See page 9 for instructions.

If Floor Nozzle stops spraying, turn Power Switch to OFF

8. ( ) and check water and cleaning solution levels. Refill if needed.

Dirty Water Tank

7