Assembly
Changing the battery
1.When completely charged, the Perfect Sweep TURBO provides up to 60 minutes of full cleaning power.
2.When charging for the first time, allow to charge uninterrupted for at least 16 hours. Thereafter, charge at least 12 hours to renew the Perfect Sweep TURBO battery. The charging indicator light will illuminate when properly connected and will not turn off when fully charged.
Note: The power switch must be in the OFF position when charging.
3.Decreased operating time may indicate the battery has built up a charging resistance. To recharge, first completely exhaust the battery, recharge it, then exhaust it again before recharging a second time. This procedure may be required more than once.
4.When charging is complete, be sure to unplug the Perfect Sweep TURBO from the charger.
ATTENTION:
If your battery still fails to recharge or does not hold a charge of normal duration, call:
BISSELL Consumer Services
Listed on page 8
Or visit our website at
www.bissell.com
Operations
Using your Perfect Sweep TURBO
The Perfect Sweep TURBO is a quick and easy way to clean your bare floors and carpet.
1.Tip back the handle into typical use posi- tion and gently tap the power switch on the sweeper with your foot.
Note: The unit will not turn on if the dirt cup is not secure.
2.To clean small areas, detach the handle by depressing the handle clip button where the bottom of the handle slides into the Perfect Sweep TURBO and pull the entire handle assembly out. Use the Perfect Sweep TURBO by holding the
3.When done, replace the handle (if detached) and store for the next use.
WARNING:
Perfect Sweep TURBO will not pick up crayons, marbles, and other large or hard objects.
1
2
5
w w w . b i s s e l l . c o m
