Clearing Clogs Continued
3.Check Upper Tank and Louvers for build up or clogs. Check to make sure Louvers are installed correctly. To unlock the Louvers, grasp the rim and turn toward the left. Pull straight down to remove. If the Louvers are missing or not locked into place, check and clear the tube in the center of the Dirt Container.
4.Remove the Twist ‘n Snap Hose from the vacuum by turning to the left. Check the Suction Inlet, Hose and Hose Wand for clogs. Remove any clogs from the hose using a long, narrow object.
5.Check the Foot Hose for clogs. If needed, remove the screw attaching the Hose Wand Base to the vacuum. Straighten the Foot Hose and unclog with a long, narrow object.
Louvers
Suction Inlet
Hose Wand Base
6. If the clog persists, follow the instructions for Checking |
|
the Rotating Floor Brush on page | Air Passageway |
Passageway for obstructions. |
Troubleshooting
WARNING:
To reduce the risk of injury from moving parts and/ or electrical shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing troubleshooting checks.
Vacuum cleaner won’t run
Possible Causes
1Power cord not plugged in
2Blown fuse/tripped breaker
Vacuum cleaner won’t pick up dirt
Possible Causes
1Incorrect Height Adjustment
2Hose not attached to suction opening
3Twist ‘n Snap Hose not securely attached.
4Crack or hole in Hose
5Broken or worn Drive Belt
6Rotating Floor Brush bristles worn
7Rotating Floor Brush jammed
8Clog in vacuum
129 Dirt Container full
Remedies
1Check electrical plug
2Check/Replace fuse or reset breaker
Remedies
1Adjust Powerfoot to correct height setting
2Grasp Quick Reach Handle and firmly push Hose Wand onto the suction opening
3Make sure Twist ‘n Snap Hose is snapped into locked position
4Check Hose and replace if needed
5Replace Drive Belt, see pg.
6Replace brush
7Remove brush and clean debris from brush ends
8Clear clog, see pg.
9Empty Dirt Container
1/4/06 9:45:59 AM |