Bissell 37000 Carpet cleaning, Empty the 2-in-1 water tank/clean removable nozzle, Lint Screen

Operations

Carpet cleaning

1.Plug the deep cleaner into a proper outlet. Turn the power ON by pressing the red power switch on the back of the unit with your foot.

2.With your foot, press the gray handle

release lever located on the back of unit	Handle Release	Power Switch
below water tank.

3.While pressing the spray trigger, make one slow forward wet pass and another back. Let the BISSELL 2X advanced deep cleaning formula and DirtLifter PowerBrush do the work for you.

Caution: Do not overwet.

4.Release the spray trigger and make one slow forward and backward pass over the same area to remove any residual dirty water and aid in drying.

5.Repeat cleaning passes until solu- tion being pulled up appears clean. Continue passes without pressing the trigger until you can’t see any more water being suctioned up.

Empty the 2-in-1 water tank/clean removable nozzle

1.Turn power switch OFF. Remove the 2-in-1 water tank from the base using the tank carry handle. Carry the tank like a bucket to a utility sink or outside where you will dispose of the collection water. Remove the top of the tank by rotating the handle forward to unlatch lid and lifting lid off tank.

2.Empty collection water from bottom of tank.

3.After each use, remove and rinse the lint screen located on the tank lid.

4.If nozzle needs to be cleaned, remove by grasping handle at the top and pulling for- ward. Clean removable nozzle by rinsing under running water.

5.When finished, replace nozzle by slightly raising front of machine to line up slots on the base with the hooks on nozzle. Attach at base first and then click nozzle into place.

NOTE: If nozzle is not attached prop- erly loss of suction will occur.

1.2.

3. Lint Screen 4.

5.

9

w w w . b i s s e l l . c o m