1.
Assembling your vacuum (continued)Twist 'n
Snap Hose
Attach vacuum hose and tools
1.Line up the tabs on the base of the Twist ‘n Snap hose with the corresponding notches on the hose collar as shown.
2.Turn the Twist ‘n Snap hose to the left to lock the hose into place.
3.Connect the curved hose wand to the hose. Grasping the curved hose wand, slide the end of the curved hose wand onto the hose wand base. Snap the hose into the hose clip.
NOTE: The vacuum will not operate effectively unless the curved hose wand is firmly attached.
4.Slide the extension wand and crevice tool together into the storage clip as shown.
5.Slide the dusting brush/upholstery tool into the storage clip as shown.
6.Attach the TurboBrush by snapping it onto the top cap of the upper tank.
Operations
Power switch
The Power Switch is located just below the handle on the front of the vacuum. Push the rocker switch “ON” (I) to vacuum, and “OFF” (O) when cleaning is complete.
6.
CAUTION:
Before using your vacuum, make sure that the dirt container is in the locked position and that all filters
NOTICE:
For above floor cleaning, the floor brush continue to rotate but is raised above floor. To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward.
CAUTION:
To avoid personal injury and to prevent the cleaner from falling when cleaning stairs, always place it at the bottom of the stairs.
6 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
9/19/06 12:31:50 PM |
