Bissell 43Z3, 18PO warranty Operation, Power switch

Assembly

Mounting & installation continued

Concrete Wall (fasteners not included)

You will need; (4) 3/8” x 2-1/4” concrete sleeve anchors.

1. Drill a 3/8” x 1-3/4” hole with a masonry drill bit.

2. Insert a bolt and anchor sleeve into the hole.

3. Align the bracket over the hole and mark remaining hole locations using the (4) outer holes of the mounting bracket; remove bracket and drill remaining holes.

4. Mount the bracket starting at top corner hole, tightly securing sleeve anchor with hex nut.

5. Repeat for three remaining holes.

6. Mount the unit by making sure the two square slots on backside of unit are sitting on the two hooks on the mounting bracket.

Mounting the Hose Holder (fasteners included)

1. Determine desired location for hose holder and screw 1-1/4” screw into stud.

(If mounting into drywall with no stud available, use supplied drywall anchors)

2. Hang holder from screw and insert 2-1/2” screw in bottom hole of hose holder to finish mounting.

3. Wrap hose around holder.

Use (4) Outer Holes To Mount Bracket

Slots

Operation

Power switch

The power switch is located on the top left side of the vacuum.

To turn vacuum on, ( I ) press up.

To turn vacuum off, ( O ) press down.

6 w w w . b i s s e l l . c o m

WARNING:

Do not remove plastic covering on power switch.

Power Switch

8 0 0 . 2 3 7 . 7 6 9 1

ug110-4046_18P0_408.indd 6

4/17/08 4:43:09 PM