![](/images/new-backgrounds/1014009/1400923x1.webp)
Rotating Brush and Drive Belt Maintenance Continued
9.Place one end of the new Drive Belt over Motor Pulley and the other end over the Brush in the space between the bristles.
10.Pull the Brush firmly to stretch the Drive Belt and place ends of Brush down into slots on sides as shown. Turn Brush several times by hand to center the Drive Belt.
11.Reposition Brush Cover and screws. Tighten screws securely.
Replace Light Bulb
Use only BISSELL Replacement Bulb
1.Unplug cleaner from electrical outlet.
2.Remove Detachable Canister and recline Handle of vacuum.
3.Using a screwdriver, remove the one screw as shown and lift off the lens.
4.Remove the bulb from the socket by pushing in gently and turning it towards brush. Install the new bulb by pushing it gently into the socket and turning away from brush.
5.Reposition lens and secure with the one screw.
WARNING:
To reduce the risk of electric shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
TurboBrush Maintenance
Select Models Only
The TurboBrush should be checked regularly for clogs or debris wrapping around the brush roll.
1.Unplug vacuum from electrical outlet.
2.If a clog is present or debris is visible, unscrew the two screws on the back of the TurboBrush to remove the faceplate and clear any obstructions.
3.To clean debris from the brush roll, remove the screw located on the belt cover. Lift the belt cover. Remove the brush roll from the drive belt and clean debris.
4.Reposition the drive belt on the brush roll. Place ends of brush roll in slots on sides as shown. Reposition belt cover and secure with shorter screw. Reposition faceplate and secure with two longer screws.
Belt Cover
12
10/3/05 3:47:58 PM |