Bissell 7887, 1200 warranty Until the wand is removed from the receiver. If

	For Manual/Hose Cleaning		1.
1.	Remove the Hose from the unit, by depressing the
	Release Button.
2.	a. Remove the Tough Stain Brush from the back
	of the unit.
	b. Attach the Tough Stain Brush onto the Flex Hose.
3.	Select the Manual/Hose button on the	2a.	2b.
	control panel.
	NOTE: In manual mode the unit will not turn on
	until the wand is removed from the receiver. If
	it is not removed with in 30 seconds of pushing
	the start button, the unit will shut off.
4. Begin cleaning by holding the tool above the
	soiled surface. Depress the Spray Trigger to apply
	the cleaning solution to the soiled area. Using
	the brush on the tool, gently scrub the area to be		3.
	cleaned. For thorough cleaning, apply additional

water and solution while brushing the soiled area you are cleaning. Apply downward pressure on the tool and pull it toward you. The suction will remove the dirt and cleaning solution. Continue until no more dirt can be removed.

5 . As a final step, use “drying strokes” (by not depressing the Spray Trigger) to remove as much liquid/moisture as possible. Repeat this step as often as necessary.

Tip:

One of the effective ingredients in Oxy GEN2 is Hydrogen Peroxide. Certain people may be affected by the product when it comes into contact with their skin; it may turn the skin white and/or cause tingling. Washing your hands after use and applying hand lotion will remove any possible white discoloration.

Tip:

If the unit accidently tips or is tilted, the Handsfree Cleaning Brushes will stop.

Tip:

Check upholstery stuffing before cleaning. Colored stuffing may bleed through the fabric when it becomes wet.

10