Bissell PowerSteamer® ProHeat™ Series Service Center Repair Guide
Printed February, 2001
1/30/2004 (Revision 1) 21
Speed Sensor Replacement 1. Remove the main housing according to instructions on page six.
2. Remove the right side wheel (held in place by an E-clip on the end of the axle).
3. Gently lift plastic retaining tab up and away from speed sensor and pull sensor out.
4. Snap new speed sensor in place.
5. Speed sensor wire should run under the power cord, then under the heater, then
around to circuit board.
Speed Sensor Wire Speed Sensor Wire