9051138 02 CHS6000 Hand SAW | 8/16/06 | 11:11 AM | Page 7 |
H |
|
|
|
ASSEMBLY |
|
|
|
HANGING THE WALL MOUNTING BRACKET
Use the hardware provided only if hanging on conventional hollow wall construction such as sheet rock or plaster walls. If not hanging on conventional sheet rock or plaster walls, please use the appropriate fasteners for that material.
•Locate the charging base within reach of an electrical outlet.
•Mark the position of both hang holes.
•Drill appropriate sized holes.
•Insert supplied hardware through hang holes and attach bracket to wall. Check to see that the charging base is firmly attached to the wall so it will not pull out.
•Plug in and place the product in position.
NOTE: Avoid damaging the cord while fixing the mounting bracket to the wall.
OPERATING INSTRUCTIONS
WARNING: Always wear proper eye and respiratory protection while operating this power tool.
•Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control.
•Place blade and shoe lightly against work to be cut.
•Switch on saw motor and allow it to obtain maximum speed before applying pressure.
TRIGGER SWITCH (FIGURE E)
The tool is equipped with a switch
•To operate the tool, slide the switch
•After the tool is running, release the switch
•To turn off, release the trigger switch. There is no provision for locking the tool on.
•Hold saw firmly with one hand or both hands (figure E) while cutting. Whenever possible, the saw shoe must be held firmly against the material being cut. This will prevent the saw from jumping or vibrating and minimize blade breakage.
BLADE CLAMP RELEASE LEVER (FIGURE F)
The CHS6000 accepts both
CAUTION: Recently used blades may be hot.
To install blade into saw:
•Push down on the blade clamp release lever (5) to its full open position as shown in Figure F.
•Insert blade shank (11) from the front.
7
