Black & Decker BV3100, BV3100R OPERATION , BLOWER MODE ASSEMBLY, VACUUM MODE ASSEMBLY

• Unlatch the fan cover from the bottom of the

vacuum

housing by pressing the

release tab (located near the front of the

vacuum

housing) and pulling the

cover open like a lid (figure B1).

NOTE: This interlock will disconnect the

electric circuit automatically and the unit will

not operate.

•

Attach the vacuum tube assembly to the

fan inlet on the

vacuum

housing (figure

C), insert the vacuum tube support tab

into the assembly slot (figure C1) on the

blower housing.

•

Push the lock button to lock the vacuum tube in place.

NOTE: This interlock will connect the electric circuit automatically and the unit

will operate.

COLLECTION BAG ASSEMBLY (FIGURE D)

NOTE:

Ensure the vacuum is switched off and

disconnected from the power supply before

attaching or removing the collection bag.

• Remove blower tube if attached.

• Push the collection bag on to the blower

housing until the lock lever engages the lock

hole as shown in figure D.

OPERATION

ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF

THE OPERATION IS DUSTY. USE OF RUBBER GLOVES AND

SUBSTANTIAL FOOTWEAR IS RECOMMENDED WHEN WORKING

OUTDOORS. FOR HOUSEHOLD USE ONLY.

WARNING: CUT HAZARD. When turning the tool off for tube

installation or any other reason, wait 10 seconds for the fan to stop

rotating before disassembly.

• Do not use in vacuum mode without the vacuum tubes and

collection bag in place.

•

Always switch off and remove the plug from the electrical supply when:

• Changing from blower to vacuum.

BLOWER MODE ASSEMBLY

NOTE: Ensure the blower is switched off and disconnected from

the power supply before attaching or removing the blower tubes.

The tube assembly must be assembled to the housing before use.

TUBE ASSEMBLY (FIGURE A)

• To attach the two piece blower tubes to the blower, line up the tube

with the blower housing as shown in figure A. Push the tube into the

blower housing until the lock lever engages the lock hole in the tube.

• To rem

ove the tube depress the lock button and slide the tube off

the housing neck.

VACUUM MODE ASSEMBLY

VACUUM TUBE ASSEMBLY (FIGURES B, C, D)

NOTE:

Ensure the

vacuum

is switched off and disconnected from

the power supply before attaching

or removing the vacuum tube. The

vacuum tube and collection bag must be

assembled to the housing before use.

The vacuum tubes must be assembled

together before use.

• Align the notches and the tabs on the two

tube pieces. (figure B)

• Push the lower tube firmly into the upper

tube, until the tabs click into place. (Never

operate apart).