ACCESSORIES
WARNING: DO NOT use this product with any type of accessory or attachment. Such usage might be hazardous.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This Class B digital apparatus complies with Canadian
TROUBLESHOOTING
Problem | Possible Cause | Possible Solution | |
• | Unit will | • Fan cover or vac tube | • Install fan cover for |
| not start. | not installed properly | blower mode or vac |
|
| • Cord not plugged in. | tube for vac mode. |
|
| • Plug tool into a | |
|
| • Circuit fuse is blown. | working outlet. |
|
| • Replace circuit fuse. | |
|
|
| (If the product |
|
|
| repeatedly causes |
|
|
| the circuit fuse to blow, |
|
|
| discontinue use |
|
|
| immediately and |
|
|
| have it serviced at a |
|
|
| Black & Decker |
|
|
| service center or |
|
|
| authorized servicer. |
|
| • Circuit breaker is tripped. • Replace circuit breaker. | |
|
|
| (If the product |
|
|
| repeatedly causes |
|
|
| the circuit breaker to trip, |
|
|
| discontinue use |
|
|
| immediately and |
|
|
| have it serviced at a |
|
|
| Black & Decker |
|
|
| service center or |
|
| • Cord or switch | authorized servicer. |
|
| • Have cord or switch | |
|
| is damaged. | replaced at a |
|
|
| Black & Decker |
|
|
| service center or |
• | Unit jammed | • Debris blocking fan. | authorized servicer. |
• Remove vac tube and | |||
|
|
| inspect inlet/outlet for |
clogs. Refer to “Cleaning and Storage Section - Maintenance”
8