Surge of Steam
Use to remove stubborn creases
Care and Cleaning
E |
F |
1.With the water tank filled to the MAX mark, set fabric selection dial to appropriate setting (between 4 and 6) for your fabric (E).
Note: See fabric guide under the heel rest and read garment's label to help you determine fabric type.
2.Be sure there is water in the tank. Steam is automatically turned off between settings 0 and 3.
3.Press the 
to generate a burst of steam (F). For best performance, leave an interval of 5 seconds between bursts.
4.When finished ironing, turn the fabric selection dial to 0 and unplug the iron.
Important: Always stand the iron on its heel rest when powered on but not in use.
Vertical Steam
This product contains no
CLEANING OUTSIDE SURFACES
1.Make sure iron is unplugged and has cooled completely.
2.Wipe the soleplate and outer surfaces with a soft cloth dampened with water.
3.Add mild household detergent. Never use abrasives,
4.After cleaning, steam iron over an old cloth to remove any residue from the steam vents.
AUTO CLEAN® SYSTEM
To keep the steam vents free of any buildup, about once a month follow these instructions.
1.Fill the water tank well below the MAX line. Plug in the iron.
2.Turn the
3.Turn fabric selection dial to 0, unplug the iron and hold over a sink with the soleplate facing down.
4. Press and hold the AUTO CLEAN® button. Be careful, as after several seconds, hot water and steam will come out of the steam
Use for removing wrinkles from hanging clothes and drapes.
1.Be sure the water tank is filled to the MAX mark.
2.Hang the garment to be steamed on a clothes hanger. (Curtains or drapes can be steamed once they are hung.)
3. Turn the fabric selection dial to appropriate setting (between 4 and
6) for your fabric.
4. Hold the iron close to, but not touching, the fabric.
5. Pull the fabric tight in your free hand and pump the 
button as you move the iron over the fabric (G).
Important: Always stand the iron on its heel rest when powered on but not in use.
G
USING SPRAY
Use to dampen tough wrinkles at any setting (H).
1. Be sure the iron is filled with water. 
2. On first use, pump the spray button 
several times.
H
IRONING WITHOUT STEAM
1. Turn the fabric selection dial to setting between settings 0 and 3 to iron without steam (J). The Smart Steam™ system will automatically
turn off.
J | 2. To dry iron at higher settings, empty the water from the tank to | |
prevent steaming. | ||
|
EMPYTING WATER TANK (OPTIONAL)
Note: It is not necessary to empty the water after each use.
1. Unplug the iron and let it cool.
2. Open the water-fill cover.
3. To release the water, hold the iron over a sink with the tip pointing down. Water will empty out of the
K
vents (L). Continue to hold the AUTO CLEAN® button until all the water has emptied. If necessary, rock iron side to side and front to back.
| 5. | When finished, release the button, stand the iron on its heel rest | |
L |
| and plug it in. | |
6. | Heat the unit for about 2 minutes to dry out any remaining water. | ||
|
STORING YOUR IRON
1. Unplug the iron and allow it to cool.
2. Check that the selector is set to 0.
3. Press and hold the cord reel button to retract the cord (M).
4.Store vertically on its heel to prevent water leaking from the soleplate.
M
5 | 6 |
