Operating Instructions |
|
Trigger Switch & Reversing Button (Figure D) | |
• The drill is turned ON and OFF by pulling | D |
and releasing the trigger switch (1). The | |
farther the trigger is depressed, the higher |
|
the speed of the drill. |
|
• A forward/reverse control button (2) | 2 |
determines the direction of the tool and | |
also serves as a lock off button. |
|
• To select forward rotation, release the |
|
trigger switch and depress the forward/ | 1 |
reverse control button to the left. | |
• To select reverse, depress the forward/ |
|
reverse control button the opposite |
|
direction. |
|
NOTE: The center position of the control |
|
button locks the tool in the off position. |
|
When changing the position of the control |
|
button, be sure the trigger is released. |
|
Torque Control (Figure E) | E |
This tool is fitted with a torque adjustment | |
collar (3) to select the operating mode and |
|
to set the torque for tightening screws. Large | 3 |
screws and hard workpiece materials require | |
a higher torque setting than small screws and |
|
soft workpiece materials. |
|
•For drilling in wood, metal and plastics, set the collar to the drilling position symbol 
•For screwdriving, set the collar to the desired setting. If you do not yet know the appropriate setting, proceed as follows:
•Set the collar to the lowest torque setting.
•Tighten the first screw.
•If the clutch ratchets before the desired result is achieved, increase the collar setting and continue tightening the screw. Repeat until you reach the correct setting. Use this setting for the remaining screws.
Keyless Chuck (Figure F) |
|
WARNING: Make certain the | F |
button is engaged to prevent switch actuation | |
before installing or removing accessories. |
|
To insert a drill bit or other accessory: | 4a 4 |
1. Grasp the rear half of the chuck (4) | |
with one hand and use your other |
|
hand to rotate the front half (4a) in the |
|
counterclockwise direction, as viewed from |
|
the chuck end. |
|
2. Insert the bit or other accessory fully into |
|
the chuck, and tighten securely by holding |
|
the rear half of the chuck and rotating the |
|
front portion in the clockwise direction as |
|
viewed from the chuck end. |
|
WARNING: Do not attempt to tighten drill |
|
bits (or any other accessory) by gripping the front part of the chuck and turning the tool | |
on. Damage to the chuck and personal injury may occur when changing accessories. | |
8
