Black & Decker LI3100 instruction manual LED Light, General Drilling Tips, Maintenance

90550370 LI3100.qxd 5/4/09 8:00 AM Page 8

•Do not use screwdriver as a pry bar in any position.

•To avoid screwdriver being turned on accidentally, do not carry in your pocket.

LED LIGHT

A light (3) is built-in to the screwdriver below the spindle (4). To use the light without the spindle turning, place the forward / reverse selector (2) in the neutral position and squeeze the trigger.

DRILLING

•Insert the appropriate hex shank drill bit.

•Select forward rotation.

NOTE: When drilling, the bit may become disconnected from the spindle upon withdrawing it from the material. Should this occur, the bit can be removed by re-inserting the hex shank into the spindle and running the tool in the reverse direction.

GENERAL DRILLING TIPS

•This tool is not recommended for drilling in masonry.

•Use sharp drill bits only.

•Drill bits for metal can be used for drilling holes in wood. These bits must be sharp and should be pulled out frequently when drilling to clear chips from the flutes.

•Support and secure work properly, as instructed in the safety Instructions.

•Use appropriate and required safety equipment, as instructed in the safety instructions.

•Secure and maintain work area, as instructed in the safety instructions.

•Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not so much as to stall the motor or deflect the bit.

•Hold the tool firmly to control its twisting action.

•DO NOT CLICK THE TRIGGER OF A STALLED TOOL OFF AND ON IN AN ATTEMPT TO START IT. DAMAGE TO THE TOOL CAN RESULT.

•Minimize stalling on breakthrough by reducing pressure and slowly drilling through last part of hole.

•Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.

•Make sure switch turns tool on and off.

WARNING: It is important to support work properly and to hold the tool firmly to prevent loss of control which could cause personal injury.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts.

BATTERY REMOVAL AND DISPOSAL

This product uses lithium-ion rechargeable and recyclable batteries. When the batteries no longer hold a charge, they should be removed from the product and recycled. They must not be incinerated or composited.

The batteries can be taken for disposal to a Black & Decker, Company-Owned or Authorized Service Center. Some local retailers are also participating in a national recycling program (see “RBRCTM Seal”). Call your local retailer for details. If you bring the batteries to a Black & Decker Company-Owned or Authorized Service Center, the Center will arrange to recycle old batteries. Or, contact your local municipality for proper disposal instructions in your city/town.

To remove the battery pack for disposal:

1.) First, before attempting to disassemble the product, turn it on and run it in either direction until it stops to ensure a complete discharge of the batteries.

2.) Remove the screws in the product housing and lift the housing half from the tool.

3.) Disconnect the terminal clips from the batteries and lift the batteries out.

4.) Place the battery in suitable packaging to prevent a short circuit of the battery terminals.

5.) Dispose of batteries as per recommended guidelines.

8