Installing / Removing Battery Pack
WARNING: Make certain the
To install battery pack: Insert battery pack into tool until an audible click is heard (figure 2).
To remove battery pack: Depress the battery release button in the back of the battery pack and pull battery pack out of tool (figure 2).
Assembly
Joining Trimmer Head Module to Handle Module
WARNING: Sharp moving blade. To prevent accidental operation, insure that battery is disconnected from the handle and that the protective blade sheath is in place on the blade before performing the following operations. Failure to do this could result in serious personal injury.
Combining the handle module (A) to the trimmer head module (B) creates a pole trimmer that is approximately 6 foot in length as shown in figure 3.
3
2 |
Transporting the Pole Trimmer
Always remove the battery from the handle and cover the blade with the blade sheath when transporting the Pole Trimmer. See page 6 for additional information on transporting the battery.
To attach the handle module to the trimmer head module: | ||
1. Align the groove on the outside of | 4 | |
the coupling end of the handle module | ||
(A) with the tongue on the inside of |
| |
the coupling end of the trimmer head | Groove | |
module (B). See | ||
figure 4. Push the two sections |
| |
completely together. |
| |
5 | ||
2. Slide the threaded sleeve (6) figure 5 | ||
on the trimmer head module down as |
| |
far as possible and rotate the sleeve |
| |
clockwise until it stops and completely |
| |
covers the orange threads as shown in |
| |
| ||
figure 6. |
| |
6 | ||
WARNING: Always check to make | ||
sure that the sleeve is completely |
| |
threaded on and that the orange |
| |
threads are no longer visible. Not |
| |
threading the sleeve completely on could |
| |
| ||
result in the modules becoming disconnected creating a hazardous | ||
condition. Periodically check the connections to insure that no | ||
orange threads are visible. |
| |
8
