Black & Decker SF-080 Assembly, FUNCTIONAL DESCRIPTION figure A, Attaching the guard Figures B, C

FUNCTIONAL DESCRIPTION (figure A)				7.	Trimmer Head
1.	On/Off Trigger Switch	4.	Auxiliary Handle
2.	Handle	5.	Height Adjust Locking Clamp	8.	Edge Guide Wheel
3.	Power Cord Plug	6.	Trimmer Guard	9.	Spool Housing

ASSEMBLY

ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED): Phillips Screwdriver

WARNING: Unplug the tool before attempting to attach the guard.

Attaching the guard (Figures B, C)

WARNING: NEVER OPERATE TOOL WITHOUT GUARD FIRMLY IN PLACE. The guard must always be properly attached on the tool to protect the user.

• Remove the screw from the guard.

• Keeping the guard square to the trimmer head slide it into place until the retaining tab clicks into place (Ensure that the guide rails (B1) on the guard (B2) are correctly aligned with the guide rails (B3) on the trimmer head (B4) (figure B).

• Secure the guard with the screw (C1) (figure C).

Attaching the Auxiliary Handle (Figures D, E)

• To attach the handle, press in on the buttons (D1) on both sides of the upper housing as shown in figure D.

• Position the handle as shown in figure E (with the Black & Decker logo facing upward). Partially push the handle on so that it will hold the buttons in when you release them with your hand.

• Push the handle completely onto the housing and position it slightly until it “snaps” into place (figure E).

• To adjust the handle up or down, press in on the button (F1) and raise or lower the handle.

• The handle should be adjusted so that your front arm is straight when the trimmer is in the working position.

Adjusting the height of the tool (figure G)

This tool has a telescopic mechanism, allowing you to set it to a comfortable height. To adjust the height setting:

• Release the height adjust locking clamp (G1).

• Gently pull the tube (G2) up or down to the desired height.

• Close the height adjust locking clamp (G1).

OPERATION

WARNING: Always use proper eye protection that conforms to ANSI Z87.1 (CAN/CSA Z94.3) while operating this power tool.

WARNING: Disconnect the plug from the power source before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

CAUTION: Before you begin trimming, only use the appropriate type of cutting line.

CAUTION: Inspect area to be trimmed and remove any wire, cord, or string-like objects which could become entangled in the rotating line or spool. Be particularly careful to avoid any wire which might be bent outwardly into the path of the tool, such as barbs at the base of a chain link fence.

Switching on and off (figure H)

WARNING: Never attempt to lock the trigger switch in the on position.

• To turn the tool on, squeeze the trigger switch (H1)

• To turn the tool off, release the trigger switch (H1).

EXTENSION Cord Retainer (figure I)

WARNING: Ensure the trigger switch is not engaged to reduce the risk of starting the tool accidentally.

A cord retainer is incorporated into the rear of the handle on the power head.

•To use the cord retainer as shown in figure I, feed the extension cord into the cord retainer housing (I1). Loop the extension cord around the cord retainer (I2) so it rests in the cord retainer. Then plug the extension cord into the power head.

6