To set the DIP switches:
1.First, disconnect the converter from the power. Then toggle Pin 2 of the DIP switch to the up position to enable the forced mode for TX port.
NOTE: Pin 2 must be toggled up before setting speed and duplex mode manually.
2.Toggle down Pin 3 to force the TX port at the speed of 100 Mbps. Or toggle up Pin 3 for
3.Toggle down Pin 4 to force the TX port at
4.Toggle down Pin 5 to force the FX port at
5.Toggle up Pin 1 to disable the
6.Connect the converter to the power again. The new setting will then take effect.
Page 12 |