Mini Cat5 VGA Transmitter w/ Local Port
2. Installation
Figure 1 – AC603A Front
2.1 Setup Connections
1.Connect the VIDEO INPUT to the computer's video port using a
2.If desired, connect a local display to the VGA out port of the Transmitter unit.
3.Using Category 5 cables connect the RJ45 port of the Transmitter to the Model AC602A Receiver.
4.Connect the Remote displays to the VGA output port of the AC602 Receivers.
5.Plug in the supplied Power supply to the Power Input jack of the Transmitter unit (can also be connected to Receiver instead).
6.Turn on the local and remote displays, then the PC
Note: If the source is Component Video (YPbPr) an HD15 to 3 RCA cable will be required for each HD15 connector.
If the source is composite video with stereo audio, a similar cable will be needed. The RCA connectors are typically yellow (instead of green) for video and red/white for audio. To transmit CV and stereo audio, you must set a dip switch per the following section.
5 |
