Chapter 4: TL500A Program Registers
REGISTER 29 — Security Access Code for Device Port 9
Contains the security access code for device port 9. This register holds up to 7 digits ranging from 0 to 9, * and #. Factory preset to 99.
WARNING: For registers 11 through 15 or 26 through 29, DO NOT program any of the security access codes to segments of the programming code (**7764#).
TO ENTER PROGRAMMING MODE
To enter programming mode, pick up the receiver of the phone that is plugged into device port 1 and dial **7764#. After dialing the string, three quick, high beeps should be heard. This affirms entry into the programming menu.
To program individual registers, press the register number you wish to program and the desired digits immediately in a contiguous string (as an example: 023 to set register 02 to a value of 3). If an error in entry is detected, a single low pitch beep will be heard followed by a short space, then three quick, high beeps. The three quick high beeps tell you to proceed.
TO RESET ALL REGISTER VALUES TO FACTORY PRESET
Press 60 while in programming mode to reset all registers to factory defaults.
TO READ VALUES FROM MEMORY
To read all values, press 99 on your telephone key pad. To read the value of a single register, press * and the
TO WRITE PROGRAMS TO MEMORY
Press 80 on your telephone key pad. This should always be done when you are satisfied with the information you have programmed.
TO EXIT PROGRAMMING MODE
Press 90 on your telephone key pad.
IMPORTANT: The TL500A MUST be the first device on the phone to ensure accurate routing. In a rollover sequence, install the TL500A on the last line of rollover.
NOTE: Device port #2 is the default fax port (can be used as a modem port).
Page 13 |