
SUPPLIED EQUIPMENT | INSTALLATION | |
|
|
|
Supplied equipment
The signal converter is supplied with all the parts listed below. Please check that the range of parts supplied with your de- vice is complete. If one of the listed parts is missing, please contact your dealer immediately.
●Signal Converter
●Connecting cable
●RGB adapter
●Installation and operating instruc- tions
Signal Converter
7 607 003 550
Connecting cable
RGB adapter
Installation
Note:
•Before connecting the monitors to your signal converter, check that the +/- and the switched positive are connected properly. After con- necting the +/- and the switched positive, the red LED on the sig- nal converter must light up!
Positive connection
Connect the fuse holder (5A fuse) to pro- tect the positive cable (3) (see Fig. 1). The fuse holder must be connected to the positive terminal at a distance of max. 30 cm from the vehicle battery (if necessary, drill a hole in the bulkhead use the appropriate cable grommets).
Switched positive
Connect the switched positive cable (4) (see Fig. 1) to the switched positive out-
put ( ) of the main system unit (e.g. car radio or navigation unit). If connect- ing to the vehicle’s terminal 15, you must connect a fuse holder (1A fuse) to pro- tect the switched positive cable (4) (see Fig. 1). The fuse holder must be con- nected to the positive terminal at a di- stance of max. 30 cm from the vehicle battery (if necessary, drill a hole in the bulkhead and use the appropriate ca- ble grommets).
Negative (earth) connection
DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS
Attach the negative cable (1) (see Fig. 1) directly to the vehicle body using a screw. Scratch the surface down to the bare metal at the point at which the earth con- tact is made and apply graphite grease (important for a good earth connection).
DANSK
13