Blaupunkt MP35 operating instructions Radio Mode, Radio mode

RADIO MODE

Radio mode

Switching to radio mode

If you are listening to CD/MP3, CD changer or AUX mode,

➮press the BND•TS 4button

or

➮press the SRC button ; repeated- ly until “FM”or “AM”(“MW”) ap- pears in the display.

Setting the tuner

In order to guarantee the perfect func- tioning of the radio element, the unit must be set for the region in which you are located. You can choose between Europe (EUROPE), America (USA), Thailand (THAI) and South America (S-AMERICA). The tuner comes from the factory set for the region in which the unit was sold. Should you encoun- ter problems with radio reception, please check this setting.

This set of instructions refers to the “USA”setting.

➮Switch off the device by pressing button 1.

➮Press and hold down the 1 and 5 buttons 9 at the same time and

switch on the device again with button 1.

“TUNER”is displayed.

➮Press the or buttons 6 within the next 8 seconds and select your tuner region.

To save the setting,

➮switch the device off and on again or wait approx. 8 seconds. The ra- dio starts with the last setting acti- vated (radio, CD (MP3), CD chang- er or AUX).

Selecting the frequency range/ memory

This unit can receive programmes broadcast over the FM and AM frequen- cy ranges. There are three memory banks for the FM range and one for the AM range. Six stations can be stored in each memory bank.

Selecting the FM memory bank or the AM frequency range respectively

➮Press the BND•TS button 4 to switch between the FM memory banks (FM1, FM2 and FMT) and the AM frequency range respec- tively.

Tuning into a station

There are various ways of tuning into a station.

Automatic seek tuning

➮Press the or button 6.

The unit tunes into the next receivable station.

Setting the sensitivity for station seek tuning

You can configure the radio to only tune into stations with a strong reception or to also tune into those with a weak re- ception.

ENGLISH FRANÇAIS ESPAÑOL PORTUGUÊS

11