Blaupunkt manual Blaupunkt Specifications VA1400, 1 Channel Amplifier

BLAUPUNKT SPECIFICATIONS - VA1400, 1 CHANNEL AMPLIFIER

All power ratings conform to CEA-2006 standards.

PARAMETER/FEATURE		VA1400
Channels		1
Size ( L x W x D) without trim panels		15.1x9.1x2.4 inches (382x231x60mm)
Weight		14.5 lbs. (6.6 kg)
Spade screw speaker terminals?		YES
Maximum terminal wire size		10 ga.
Subsonic filter		YES (10 Hz)
Separate front/rear or left/right gains?		N/A
Fuse Type		ATC spade -Two 40A
Speaker short, short to +12V, and short to ground protection?		YES
High, low, and reverse voltage protection?		YES
Power output transistors		Low QZ MOSFET
Power supply transistors		MOSFET
Minimum speaker impedance	(non-bridged)	2 ohms
	(bridged)	N/A
PERFORMANCE DATA
Rated power output @ 0.1% THD, 14.4V (CEA-2006)
1 channel into 4 ohms	(watts rms)	1 x 100 W
1 channel into 2 ohms	(watts rms)	1 x 600 W
Max Dynamic Power (watts rms)		700W
Total Harmonic Distortion @ full power		0.3% THD
Signal/Noise ratio (gain controls in center)
Measured @ 1 watt / 1 kHz	dBA	>80
Measured @ full rated power (0.1% THD)	dBA	>100
Damping factor		>100
Frequency response (full-range mode)		50 - 250 Hz
High-pass crossover frequency limits		N/A
Low-pass crossover frequency limits		50 H z - 250 Hz (variable), 12dB/oct
Input impedance		10 kohms
Input signal voltage control range		0.3 - 8.0 vrms
Current Draw @ 13.8 VDC (typical values @ X watts / Efficiency %)
@ full rated power, unbridged	(@ 4 ohms)	50 A (50%)
@ 33% rated power, unbridged	(@ 4 ohms)	30 A (35%)
@ idle	(@ 4 ohms)	1 A
Minimum battery voltage to maintain rated power		12.6 VDC
Usable battery voltage		10 - 16 VDC
Trigger line voltage range		10 - 16 VDC
Trigger line current draw		< 20 mA
Turn on delay time		@ 2.0 seconds
Thermal shutoff temperature (average heat-sink temp)		@ 85˚ C (185˚ F)

This information is subject to change without notice!

– 1 –

www.midwestelectronics.com