Contact 1.800.762.1142 for assistance.
Do not return to place of purchase.
Step 8 – Assemble dome
Note: Each dome section has a pin mounted in place in the rolled bottom edge.. If necessary for proper alignment of dome sections, loosen each screw prior to further assembly and retighten after sections are aligned..
•With the large side facing up, slide a dome rib on to the same side of one dome section as the pin.. Slide two dome sections together, allowing the exposed end of the pin slide into the rolled edge of the next dome section.. Line up hole in dome with threaded hole in pin..
•Insert one Dome Screw and secure loosely..
•Repeat procedure to complete the assembly of all three sections..
•Slide Dome bolt through bottom check plate (with small center hump), being sure that the rolled edge faces down..
•Slide bolt from previous step through the center of the assembled dome sections, and be sure that the rolled edge of the check plate fits inside of the ends of the three Dome Ribs.. Also be sure that the slots in the check plate line up with the holes on the dome sections..
•Slide the other check plate over the Center bolt with the rolled edge facing up, again making sure that the plate fits inside of the Ribs and the holes line up with those in the dome..
•Spin the medium nut all the way down the bolt, clamping all of the pieces in place, making sure that all of the humps fit inside one another..
•Fully tighten all of the screws in the rolled edge..
Step 9 – Attach Dome to Emitter
Line up holes in dome assembly with the studs from the emitter assembly and lay dome assembly in place.. Secure with three nuts..
Place dome cap over center bolt, making sure that the three slots in cap lay over each Rib
Thread on finial until tight..
Owner’s manual: model 200605C outdoor patio heater | 10 |