Blue Rhino NSG3902B manual 6

Outdoor Gas Grill Model No. NSG3902B

Operating Instructions

Checking for Leaks

Burner Connections

Direct Cooking

1.	Light burners per lighting instructions.
2.	Set burners to desired level and allow temperature to be reached.
3.	Place food directly over burners.

Make sure the regulator valve and hose connections are securely fastened to the burner and the tank.

If your unit was assembled for you, visually check the connection between the burner pipe and orifice. Make sure the burner pipe fits over the orifice.

WARNING: Failure to inspect this connection or follow these instructions could cause a fire or an explosion which can cause death, serious bodily injury, or damage to property.

Please refer to diagram for proper installation.

If the burner pipe does not rest flush to the orifice, please contact 1.800.762.1142 for assistance.

Tank/Gas Line Connection

Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.

Make sure control knobs are off. Turn LP gas tank ON at valve.

Spoon leak check solution at all “x” locations

Gas Valve with orifice

Burner

Venturi

Gas

Connections

Main Burners

Gas

Connections

Burner

Venturi

Gas Valve with orifice

Side Burner

X

X

X

X

X

4. With lid open or closed, cook untill desired internal temperatures are acheived.
Indirect Cooking
Ideal for roasts and larger cuts of meat.
1.	Remove cooking grid.
2.	Place metal tray in center, on heat plates.
3.	Replace cooking grid.
4.	Light burners.
5. Turn center burner off. Set ouside burners to desired level and allow temperature to
	be reached.
6.	Place food on cooking grid, directly over metal tray.
7. With lid closed, cook until desired internal temperatures are achieved.

Tips For Better Cook Outs and Longer Product Life

1.Spray or coat cooking surfaces with vegetable oil before cooking to avoid sticking.

2.Place vegetables or delicate foods into aluminum foil pouches.

3.Use a quality grill brush after each event to keep cooking surfaces clean and rust free.

4.Empty grease pan after every use.

CAUTION: Do not cover grill until it is completely cool to the touch.

Operating Side Burner

NOTE: Side burner can be used while main burners are operating.

Never use side burner as a grill.

Lighting

If any bubbles appear turn LP gas tank OFF, reconnect and re-test. If you continue to see bubbles after several attempts, disconnect LP gas source and contact 1.800.762.1142 for assistance.

If no bubbles appear after one minute turn tank OFF, wipe away solution and proceed.

Operating Main Burners

Lighting
1. Open lid. Attempting to light the
burner with the lid closed may
cause an explosion!
2. Make sure there are no				1/2"
obstructions of airflow to the gas	Flame	12.7 mm
unit. Spiders and insects can nest
			1/4"
within and clog the burner / venturi	Burner
			6.4mm
tube at the orifice. A clogged
burner tube can lead to a fire					0"
beneath the appliance.
			0mm
3. All control knobs must be in the
	Main burner proper flame height.
OFF position.

4.Turn on gas at LP gas tank.

5.Push and turn control knob counterclockwise to HIGH.

6.Press the electronic igniter button and hold for 5 seconds to light burner.

7.If ignition does not occur in 5 seconds, turn burner control knob OFF, wait 5 minutes, and repeat lighting procedure.

8.If igniter does not light burner, use a lit match secured with the lighting rod provided to light burners manually. Access the burners through the cooking grid and heat plates. Position the lit match near side of the burner.

Important: Always use the lighting rod provided when lighting burners with a match.

9.After lighting, observe the burner flame, make sure all burner ports are lit and flame height matches illustration.

CAUTION: If burner flame goes out during operation, immediately turn the gas “OFF” and open lid to let the gas clear for about 5 minutes before re-lighting.

Turning Off

1.Turn all control knobs clockwise to the OFF position one at a time.

2.Turn gas off at LP tank.

Initial Use

Before cooking on this grill for the first time, operate the grill for about 15 minutes with the lid closed and the gas turned on “HIGH.” This will “heat clean” the internal parts and dissipate odor from the manufacturing processes.

1. Open lid. Attempting to light the
		Flame
burner with the lid closed may
cause an explosion!	Burner
2. Make sure there are no
obstructions of airflow to the gas
unit. Spiders and insects can nest
within and clog the burner / venturi	0"	3/8"	3/4"
tube at the orifice. A clogged
burner tube can lead to a fire	0 mm	9.5 mm	19 mm
beneath the appliance.	Side burner proper flame height.

3.Control knob must be in the OFF position.

4.Turn on gas at LP gas tank.

5.Push and turn control knob counterclockwise to HIGH.

6.Press the electronic igniter button and hold for 5 seconds to light burner.

7.If ignition does not occur in 5 seconds, turn burner control knob OFF, wait 5 minutes, and repeat lighting procedure.

8.If igniter does not light burner, use a lit match secured with the lighting rod provided to light burners manually. Position the lit match near side of the burner.

Important: Always use the lighting rod provided when lighting burners with a match.

9.After lighting, please observe the burner flame, make sure all burner ports are lit and flame height matches illustration.

CAUTION: If burner flame goes out during operation, immediately turn the gas “OFF” and open lid to let the gas clear for about 5 minutes before re-lighting.

Turning Off

1.Turn control knob clockwise to the OFF position.

2.Turn gas off at LP gas tank.

Cooking

1.Light burner.

2.Set burner to desired temperature

3.Place pan on center of grid.

4.Cook and adjust temperature as needed.