Blue Rhino PG2620 manual 29

Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Troubleshooting

Problem	Possible Cause	Prevention/Cure
Burner will not light using	Wires/or electrode covered with cooking	Clean wire and/or electrode with rubbing
ignitor	residue.	alcohol.
	Electrode and burners are wet.	Wipe dry with cloth.
	Electrode cracked or broken - sparks at	Replace electrode.
	crack.
	Wire loose or disconnected.	Reconnect wire or replace electrode/wire
		assembly
	Wire is shorting (sparking) between ignitor	Replace ignitor wire/electrode assembly
	and electrode.
	Bad ignitor.	Replace ignitor
Burner will not light with	No gas flow.	Check if LP tank is empty. If LP tank is not
match		empty, refer to “Sudden drop in gas flow
		(reduced flame height). If empty, replace or
		refill.
	Coupling nut and regulator not fully	Turning the coupling nut about one-half
	connected.	to three quarters additional turn until solid
		stop. Tighten by hand only-do not use
		tools.
	Obstruction of gas flow.	Clear burner tubes. Check for bent or
		kinked hose.
	Disengagement of burner to valve.	Reengage burner and valve.
	Spider webs or insect nest in venturi.	Clean venturi.
	Burner ports clogged or blocked.	Clean burner ports.
Sudden drop in gas flow	Out of gas.	Check for gas in the LP tank
or reduced flame height	Excess flow safety device may have been	Turn off knobs, wait 30 seconds and light
	activated.	grill. If flames are still too low Reset the
		excessive flow safety device by turning
		off knobs and LP tank valve. Disconnect
		regulator. Turn burner control knobs to
		HIGH. Wait 1 minute. Turn burner control
		knobs off. Reconnect regulator and leak
		check connections. Turn LP tank valve on
		slowly, wait 30 seconds and then light grill.
Irregular flame pattern,	Burner ports are clogged or blocked.	Clean burner ports.
flame does not run the full
length of burner.

Owner’s manual: model PG2620 outdoor gas grill 5/29/03 28