4. Route the Kenwood bus-lead from the front of the vehicle to the left-hand side of the boot compartment.
5. (BMW) In the boot compartment of the car, remove the trim panel on the left hand side to reveal the
mounting area for the changer.
6. Connect the Kenwood bus-lead to the BRLK2 interface.
7. Connect the Kenwood bus-lead to the CD changer.
8. (BMW) Remove plastic trim around glove box with a flat blade screwdriver or trim fork; remove retaining
screw holding the continuation of trim around head unit. This will then reveal the screws holding the
head unit in position remove them and pull the head unit forward.
9. (Mini) Remove the 4 Torx bolts from either side of the struts surrounding the head unit, and then remove
the screws securing the ashtray and centre console.
10. (Mini) Remove the 2 side struts and centre console to reveal 4 screws holding the head unit in the dash,
remove these and pull the head unit forward.
11. (MGF & Freelander) Remove head unit by using a hex tool, slacken the hex screws in the radio and pull
the radio towards you.
12. (Rover) Remove trim piece from above radio held in place with two screws covered by plastic caps. Once
the trim is removed this reveals the top of the head unit. Two further screws hold the head unit in place
remove these and locate the two horizontal slots at the bottom of the head unit. Using two flat blade
type removal keys remove the head unit.
13. Locate on the harness to the connector, the wire to (Pin 9) Permanent Live and solder the Red onto.
Locate on the harness to the connector, the wire to (Pin 7) Data and solder White onto. Locate on the
harness to the connector, the Earth (Pin 15) and solder the Brown onto (See attached diagram for
reference).
14. Locate CD changer connection in back of head unit and insert black 10-Pin audio plug from the interface –
the plug is handed and will only connect in one way (See attached diagram for reference).
15. Re-connect the negative terminal of the battery and verify full working operation via the radio.
16. Refit the head unit.
17. (Mini) Mount the CD changer to the under side of the back shelf as per manufacturers instructions.
18. (Freelander) Mount the CD changer beneath the passenger seat as per manufacturers instructions.
19. (BMW) Mount the CD changer into the factory fitted mounting bracket* by means of modifying the BMW
bracket or installing elsewhere as per manufacturers instructions.
20. Mount the CD changer as per manufacturers instructions.
*It may be advisable to visit your local car radio dealer for modifying the bracket as this can prove to
be a difficult operation.
WARRANTY
This product is covered by a 24 month warranty from the date of purchase.
If the interface Bar code is tampered with or removed all Warranties will be Void.
(Version 1.0)
2