Amplified Speakers
Models AS1, ASUG1(DK), and ASWG1(DK)
Installation and Use Manual
Description
Bogen’s
Model | Style | Power | Power | Mounting Accessories | |
Requirements | Rating | ||||
|
|
| |||
|
|
|
|
| |
AS1 | Unmounted Cone Speaker with 1W Amplifier and |
|
| Grilles: CG8A, CG8AW, | |
Volume Control |
|
| SG8W, PG8A, PG8U, PG8W | ||
|
|
| |||
|
|
|
|
| |
ASUG1, | AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W) | 1 CU | 1W |
| |
ASWG1 | with Fixed, Volume Control Knob | (50 mA) |
| ||
| TB8, RE84, MR8 | ||||
|
|
|
| ||
ASUG1DK, | AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W) |
|
| ||
|
|
| |||
ASWG1DK | & Detachable Volume Control Knob |
|
|
| |
|
|
|
|
|
Installation Instructions for ASUG1(DK) and ASWG1(DK)
Note: Do not mount the speaker near noise generating equipment (fans, motors, etc.) and do not use where a normal conversation cannot be conducted.
TB8 and RE84 Installation
1. Place ceiling tile with the finished side facing up over a large trash can (to provide support and save cleanup time).
2. Cut hole in the center of the ceiling tile, using the raw speak- er as a guide.
3. Bend (4) horseshoe tabs upward on tile bridge.
4. Position the tile bridge on the unfinished side of the ceiling tile and bend (4) locator tabs into tile opening to prevent sliding.
5. Slip
6. Punch out knockout in the RE84. Install listed metallic enclo- sure entry fitting to knockout to accommodate plenum cable or plenum. Whip and feed cable or whip through the knock- out.
7. Install RE84 to tile bridge by orienting horseshoe tab slots (4) over horseshoe tabs (4) of bridge.
8. With pliers, twist horseshoe tabs (4) of tile bridge 1/2 turn, securing enclosure to bridge.
9. Screw the Ceiling Speaker assembly to the RE84 using (4)
© 2004 Bogen Communications, Inc. All rights reserved.
Specifications subject to change without notice.