Flush- and Surface-Mount Back Boxes
Models BBF and BBS - Installation and Use Manual
1A: BBS Installation
1. Install BBS back box on wall, making sure that the box is squarely mounted. Allow free access above box for AC wiring and above or below box for audio wiring.
2.Have power wiring run near upper
3.Secure box on wall with screws through back holes (4 screws).
2: Junction Box Wiring
1. Supply AC power to unit through conduit, BX or ROMEX in accordance with local electrical codes.
2.Snap AC receptacle into junction box (GND pin down) and connect wires as shown using wire nuts.
3.BBF - Install junction box in BBF and secure with four #6 x 3/8 screws.
BBS - Install junction box in BBS and secure with four
3: Preparations Before Installing Amplifier
1. Run all audio leads into wall box. The preferred arrangement is for output leads to enter through the top and input leads to enter through the bottom. Use knockouts as necessary. Make sure wires do not rest against sharp edges of box.
2.Install hinges (packed with amplifier) using 6 #8 x 3/8 screws. Do not install middle screws of lower hinge (used for ground strap connection - see 4).
3.Check to see that AC power is available at the outlet.
4:Amplifier Installation
1. Mount amplifier on back box by aligning hinge pins and lowering into place.
2.Connect ground strap by inserting middle hinge screws through lugs of ground strap as shown in illustration. Ground strap must be installed to meet UL requirements.
3.Make necessary input and output con-
nections (care should be taken to |
|
keep input and output leads separated | Output |
as much as possible). |
4. With power switch turned off, plug AC cord into side outlet on junction box.
5. Turn amplifier ON and check connections.
6.Secure amplifier using three
5: Front Panel Mounting
1. Mount front panel (but do not tighten) with four
2. Install two #8 x 3/8 screws on inside lips of door opening, then tighten all mounting screws. Do not overtighten as
3.Check to see that door opens and closes correctly.
1B: BBF Installation
1. Prepare mounting hole for BBF back box. Hole size should be
2. Have power wiring run near upper
3. Install BBF back box in wall, making sure that the box is squarely mounted and the front sur- face flush with the finished wall. Use shims if necessary. Allow free access above box for AC wiring and above or below box for audio wiring.
4.Secure box in wall with screws through side slots (4 screws).
5.With box positioned, install 4 additional screws in holes next to slots.
BBF
Junction Box
BBS
BBF
Input
Ground Strap
Specifications subject to change without notice. |
|
|
|
|
|
| |
© 2005 Bogen Communications, Inc. | 50 Spring Street, Ramsey, NJ 07446, U.S.A. | ||
Part No. | Tel. |