Bogen KFLDS30T installation instructions Wide Dispersion, 30W Horn Loudspeaker, Tap

KFLDS30T

Wide Dispersion, 30W,

Horn Loudspeaker

Installation Instructions

1.Unscrew wing nut and remove threaded pin to separate the mounting base from the horn. Use the base as a template for the mounting holes. Drill three mounting holes and attach the base using appropriate hardware (not included). See Figure 1

IMPORTANT: Make sure the base sits flat on the mounting surface. Tightening the base down on an uneven surface could cause the base to fracture.

The speaker can be mounted to an I-beam flange using Bogen's accessory BC1 Beam Clamp. The slot in the base also allows strapping to be used as a means of mounting the horn (use a strapping material capable of supporting the weight of the speaker and any external loads on the horn such as wind).

2.Reassemble horn on to base after it has been mounted.

3.Remove the plastic cover to make the electrical connections (see Figure 2). Connect the 70V or 25V “hot” lead to the #1 terminal and the system common lead to the #2 terminal. Follow this pattern on all similar speakers to ensure proper phasing; however, the speakers will work perfectly well if the connec- tions are reversed.

4.Adjust the tap selector switch to the desired wattage using the chart below and secure the plastic cover back in place.

TAP	70V	25V	IMPORTANT:
SET	WATTS WATTS		DO NOT
			use positions
1	1.8	.25
			marked as "*"
2	3.7	.5
3	7.5	.9
4	15	1.8
5	30	3.7
6	*	7.5
7	*	15
8	*	*

5.Loosen Wing Nut, tilt and swivel the horn to the desired orientation, then re-tighten. Hand tighten wing nuts. Do not use pliers or tools.

Figure 1

TAP SET

CONTROL

ELECTRICAL

CONNECTION Figure 2

BC1 Beam Clamp

(optional accessory)

©2005 Bogen Communications, Inc. Specifications subject to change without notice. 54-2138-01A 0505