Bogen MA3 specifications

Module Adapter Kit Model MA3

Specifications subject to change without notice.

54-2127-01B 0409

The MA3 Module Adapter Kit allows Bogen’s latest line of input modules to work with the D-Series line of amplifiers

(Models DMA40,DMA80, DMA160, DMP06,and DPA160). One MA3 kit can adapt up to 3 modules in a single D-Series amplifier.

Two MA3 kits can be used in the same D-Series amplifier to adapt up to 6 modules.

Note:Signal-processing output modules are not compatible with the D-Series line of amplifiers.

Master Adapter

A master adapter must always be installed,but the two slave adapters are

optional and may be installed on an as needed basis.

1. Connect the power supply to the adapter.Wire tie the power supply

cord to the connector if desired.

2. Connect the module to the adapter and slide the power supply cord below

the module.

3. Insert the two screws supplied with the module through the module screw

holes and then through the two washers,with the larger washer first and

the smaller retaining washer second.Then, insert the module and adapter

into the module bay by sliding them along the card guides inside the

module bays. Secure them to the chassis using the two screws.A gap

between the unit’s back panel and the module will exist to allow the power

supply wire to exit.

Slave Board

Once the master module adapter is installed,the slave adapters can be

installed if needed.Slave adapters will not work without a master adapter.

1. Connect the module to the adapter.

2. Insert the module and adapter into the module bay by sliding them along

the card guides inside the module bays.Use the two screws supplied with

the module to secure it to the chassis. No washers are used and the

module should be flush with the unit’s back panel.

Master Adapter

Slave Adapter

(X2)

Power Supply

Wire tie the power supply

cord here if desired

D-Series Amp

• Master Board

• 2 Slave Boards

• Power Supply

• Wire Tie

• 2 Washers (large)

• 2 Washers (small retaining)