SECTION 3: ASSEMBLING YOUR LAWN MOWER

Removing Unit From Carton

Remove staples, break glue, or cut tape at carton end and peel along top flap to open carton.

Remove loose parts if included with unit (i.e., operator’s manual, etc.)

Carefully cut along corners, lay carton down flat, and remove packing material.

Roll or slide unit out of carton and check carton thoroughly for loose parts.

Before Assembly

NOTE: Reference to right or left hand side of the mower is observed from the operating position.

Before setting up your lawn mower, disconnect the spark plug wire from the spark plug and ground against the engine. See Figure 1.

Bolt

Spark Plug

Wire

Spark

 

Plug Wire

Spark Plug

 

Figure 1

Setting Up Your Lawn Mower

Lift up and pull back on the upper handle to raise the handle into the operating position. Make certain the lower handle is seated securely into the handle bracket assemblies.

Tighten the two wing nuts on two sides to secure the upper handle to the lower handle (carriage bolts must be seated properly into the handle). See Figure 2 for location of wing nuts.

Upper Handle

Lower

Handle

Wing Nut

Figure 2

Tighten the wing nuts at the end of the lower handle to secure the handle to handle bracket assemblies. See Figure 3.

Lower

Handle

Wing

Nuts

Handle

Bracket

Assemblies

Figure 3

Fasten the cable to the lower handle with the cable tie found on the lower handle. Pull the cable tie tight and trim off the excess. See Figure 4.

Cable Tie

Lower

Handle

Figure 4

Attaching Rope Guide

If not already attached to the upper handle, insert rope guide into the first hole on the upper handle as indicated in Figure 5. Secure the rope guide to handle with wing nut, but do not tighten.

Starter

Upper Handle

Rope

 

 

Wing Nut

Rope

Guide

Lower

Handle

Figure 5

With the spark plug wire disconnected and grounded, hold the blade control handle against the upper handle, and pull the starter rope out of the engine. Release the blade control handle. Slip the starter rope into the rope guide. Tighten wing nut.

7

Page 7
Image 7
Bolens 84 manual Assembling Your Lawn Mower, Removing Unit From Carton, Before Assembly, Setting Up Your Lawn Mower