ASSEMBLY INSTRUCTIONS

INSTALL AND ADJUST THE J-HANDLE

1.Place the J-handle between the top and middle clamp pieces (Fig. 1).

(4) Screws

Top Clamp

J-Handle

Middle Clamp

 

Bottom Clamp

Nuts

 

 

Fig. 1

2.While holding the three pieces together, install the four

(4) screws through the top clamp and into middle clamp.

NOTE: The holes in the top and middle clamp will line up only when assembled correctly.

3.Place the clamps and the J-handle over the shaft housing and onto the bottom clamp.

4.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.

5.Slide the J-handle in or out until the arrow/white line on the decal touches the clamp assembly (Fig. 2). You must first loosen the screws if the handle is pre-installed.

Decal

Fig. 2

6.While holding the unit in the operating position (Fig. 26), position the J-handle to the location that provides you the best grip.

7.Tighten the clamp screws evenly, until the J-handle

BL26C0 ONLY: INSTALL THE CUTTING SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed.

WARNING: Never operate the trimmer without the

cutting attachment shield in place to prevent serious personal injury.

1.Place the cutting attachment shield onto the shaft housing above the clamp assembly (Fig. 3).

2.Push the cutting attachment shield down to the top of the cutting attachment assembly and then rotate the cutting attachment shield until the screw holes align and the guard fits into the recessed pocket (Fig. 3).

3.Install the screws with a Phillips screwdriver (Fig. 4).

Clamp

Assembly

Recessed

Cutting Attachment

Pocket

Shield

 

Fig. 3

(4) Screws

Fig. 4

8