LTC 9312 Series Instruction Manual Unpacking

EN 3

 

 

1

UNPACKING

3

INSTALLATION

This mechanical equipment should be unpacked and handled carefully.

Check for the following items:

Qty. Item

1LTC 9312/00

1Clear dome

2Support channels

1 Black opaque liner

1 FM2 camera bracket assembly

1 Black dust cover

If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any items are missing, notify your Bosch Security Systems Inc. Sales Representative or Customer Service.

The shipping carton is the safest container in which the unit may be transported. Save it for possible future use.

2SERVICE

If the unit ever needs repair service, the customer should contact the nearest Bosch Security Systems, Inc. Service Center for return authorization and shipping instructions.

Service Centers

USA

Phone: 800-366-2283 or 717-735-6638 fax: 800-366-1329 or 717-735-6639

CCTV Spare Parts

Phone: 800-894-5215 or 408-956-3853 or 3854 fax: 408-957-3198

e-mail: BoschCCTVparts@ca.slr.com Canada

Phone: 514-738-2434

Europe, Middle East & Asia Pacific Region Phone: 32-1-440-0711

For additional information, see www.boschsecuritysystems.com.

1.Remove the contents from the box.

2.Remove the ceiling tile in the desired location.

3.Place the acrylic dome in the chosen location; the dome will rest on the ceiling grid. (Be sure the grid is adequately supported.)

4.Using a utility knife or scissors, carefully cut a hole in the black opaque liner, for the camera to view through.

NOTE: Smaller cutouts allow more discreet viewing.

5.Place the black opaque liner into the acrylic dome and rotate it to the desired viewing position.

6.Align the long slots of two FM2 camera bracket arms.

7.Using a carriage bolt, 5/16in. washer, 1/4in. washer, lockwasher, and hex nut, attach the bracket arms together loosely. See FIGURE 1.

8.Slide the smaller channel through the slot on the larger support channel. See FIGURE 2. Use the 1/4 x 20 bolt supplied to connect the FM2 to the support channels (via the center hole in the two channels). BE CAREFUL WHEN HANDLING THE SUPPORT CHANNELS; EDGES MAY BE SHARP.

9.Securing tabs are provided to hold the bracket between the liner. Bend the corresponding tab with a screwdriver.

10.Connect the camera to the FM2 bracket, and place the assembly in the dome so the edges of the bracket rest on the flange of the dome.

11.Tighten all connections and complete wiring the camera.

12.A tex-wipe is provided to clean the dome.

13.Place the black dust cover over the top of the dome, so the dust cover is sitting on the supporting channels.

USE ONLY WITH A CLASS 2 POWER SUPPLY.

For added flexibility, the camera can be mounted on either the short or the long side of the bracket arm.

Bosch Security Systems 28 July 2004

Page 3
Image 3
Bosch Appliances LTC 9312/00 instruction manual Unpacking