Plena Mixer Amplifier Installation and User Instructions Connections and settings

en 15

4Connections and settings

4.1Connecting inputs

4.1.1Priority microphone (input 1)

The priority microphone (or a generic call station) that can be used with push to talk (PTT) should be connected to “microphone/line 1 input”. The PTT mode can be activated by setting the DIP switch (12) at the rear of the unit. Microphone/line 1 input has priority over all other microphone/line inputs.

If, however, the “Tel. emergency/100V input” receives a signal, all inputs including microphone/line 1 input will be overruled.

The microphone/line 1 input has two connectors wired in parallel:

an XLR connector (for a 3 pole microphone), and

a Euro style pluggable screw terminal connector.

The Euro style pluggable screw terminal connector has a trigger input, which can be used in combination with the Euro and XLR connector.

The priority microphone can be connected to the microphone/line 1 input as follows:

XLR connector only. See figure 4.1.

XLR connector with trigger. See figure 4.2.

Euro connector with trigger. See figure 4.3.

Euro connector only (without trigger).

Note

If a microphone is connected to both the XLR connector and the Euro connector for the microphone/line 1 input, the input signals will be added together.

Set the DIP switch settings next to the XLR connector for microphone/line 1, as required. See section 4.3.

Note

When connecting an unbalanced line level (200 mV) signal to the microphone/line input, connect it as follows: Signal to pin 2, pin 1 and pin 3 to ground.

figure 4.1: XLR connector only

figure 4.2: XLR connector with trigger

figure 4.3: Euro connector with trigger

Bosch Security Systems 2007-11 PLE-1MA030-EU, PLE-1MA060-EU, PLE-1MA120-EU en

Page 15
Image 15
Bosch Appliances PLE-1MA030-EU, PLE-1MA060-EU manual Connections and settings, Connecting inputs, Priority microphone input