Bosch Power Tools 11224VSRC manual Operating Instructions, Removing SDS-plusACCESSORIES

Operating Instructions

INSTALLING SDS-plus®ACCESSORIES Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant

Insert accessory into the tool holder through the dust shield, while twisting and pushing inward until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the tool holder (Fig. 2).

NOTE: The high efficiency available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The "cost" to maintain sharp and undamaged

FIG. 2	DUST
	SHIELD

accessories is more than offset by the "time saved" in operating the tool with sharp accessories.

REMOVING SDS-plus®ACCESSORIES

!Accessories may be hot after WARNING use. Avoid contact with skin

and use proper protective gloves or cloth to remove.

To remove an accessory, pull and hold locking sleeve backward and pull bit forward. All accessories should be wiped clean after removing (Fig. 3).

	LOCKING
FIG. 3
	SLEEVE

CHANGING THE CHUCK

Do not carry the tool by the ! WARNING chuck. Tool may unexpectedly

fall if the chuck is not fully engaged.

The SDS-plus chuck can easily be exchanged for the 3-jaw chuck supplied with you tool.

Hammer drilling and chiseling are only possible when using the SDS-plus chuck with SDS-plus shank accessories.

The 3-jaw chuck converts your tool for use with a variety of straight shank bits for drilling and driving.

LOCKING RING

FIG. 4

REMOVING THE SDS-plus®CHUCK

Grasp the locking ring of the SDS-plus chuck and pull forcefully in direction of arrow and remove from tool (Fig. 4).

ATTACHING THE 3-JAW CHUCK

Grasp the 3-jaw chuck firmly with your hand and push it onto the tool with a twisting motion until you hear it lock into place (Fig. 5).

Pull outward on the chuck to be certain it is locked into the tool.

FIG. 5

3-JAW

CHUCK

-7-