BM 1619929843
Assembly
INSTALLING ACCESSORIES
Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant.
(Model 11264EVS
Insert accessory into the tool holder, while twisting and pushing inward until it locks automatically into place (Fig. 2).
(Model 11265EVS
To install hex round chisels, align flat on chisel with alignment mark on tool holder, then push chisel into tool holder until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the tool holder (Fig. 3).
REMOVING ACCESSORIES
!WARNING Accessories may be hot after use. Avoid contact with skin
and use proper protective gloves or cloth to remove.
(Model 11264EVS
To remove an accessory, pull locking sleeve backward until it locks into place, then pull bit forward. All accessories should be wiped clean after removing (Fig. 2).
(Model 11265EVS
To remove an accessory, pull and hold locking sleeve backward and pull bit forward. All accessories should be wiped clean after removing (Fig. 3).
NOTE: The high efficiency available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The "cost" to maintain sharp and undamaged
accessories is more than offset by the "time saved" in operating the tool with sharp accessories.
FIG. 2 |
LOCKING SLEEVE |
HEX ROUND CHISEL | FLAT |
| ALIGNMENT |
| MARK |
FIG. 3 | LOCKING |
SLEEVE |
AUXILIARY HANDLE
The tool must be supported with the auxiliary handle, which can be swiveled 360˚. To reposition and/or swivel the handle, loosen the hand grip, move the handle to the desired position along the barrel and securely retighten the hand grip.
VIBRATION DAMPER HANDLE /
HAMMER MECHANISM
The integrated vibration damper in the main handle and hammer mechanism reduces vibrations (Fig. 1).
Operating Instructions
POWER INDICATOR LIGHT
When you plug your tool into the power source, the power indicator light will go “ON” indicating the tool is receiving power.
SLIP CLUTCH
The tool has a internal
