Bosch Power Tools 1294VSK manual Operating Instructions, Slide ON/OFF Switch

Operating Instructions

SLIDE "ON/OFF" SWITCH

The tool is switched "ON" by the slide switch located on the topside of the motor housing.

TO TURN THE TOOL "ON" slide the switch button forward.

TO TURN THE TOOL "OFF" slide the switch button backward.

Hold the tool with both ! WARNING hands while starting the

tool, since torque from the motor can cause the tool to twist.

VARIABLE SPEED DIAL

This tool is equipped with a variable speed dial. The speed may be controlled during operation by presetting the dial in any one of six positions.

Dial setting	Material/Application
3 thru 5	Delicate surfaces, veneers, or
	light surface finishing &
	polishing
3 thru 5	Plastics or other soft surfaces
4 thru 6	Solid wood, fast stock removal,
	paint removal
3 thru 6	General service, metal sanding
	& finishing, chipboard, coarse
	sanding on rough surfaces, &
	polishing

BACKING PAD INSTALLATION

Your BOSCH corner/detail sander is equipped with a hook-and-loop rubber backing pad which may be removed and attached without the need of additional tools. To remove, push the pad lock button to the right as far as possible and pull the backing pad free of the sander. (For maximum use of abrasive, rotate pad 120 degrees when tip of abrasive becomes worn.) To replace, push backing pad back into place, and secure with the pad lock button.

When sanding in extremely tight areas, such as louvered panels, optional extension plates are available.

Your Bosch sander uses hook-and-loop backed accessories, which firmly grip the backing pad when applied with moderate pressure. To change, merely peel off the old accessory, remove dust from the backing

pad if necessary, and press the new accessory in place. Be sure to align the sanding sheet holes with the holes in the backing pad to allow the dust extraction system to function.

After considerable service the backing pad surface will become worn, and the backing pad must be replaced when it no longer offers a firm grip. If you are experiencing premature wearout of the backing pad facing, decrease the amount of pressure you are applying during operation of the tool.

DUST EXTRACTION

The integral dust port collects sanding dust in a shop vacuum when fitted with the optional Bosch Airsweep hose. However, the sander may be operated without the dust collection system if desired, as it will not harm the tool. See your Bosch dealer for optional Bosch Airsweep accessories.

"Tool Tips"

This machine is particularly suitable for one handed operation, and access to corners and edges that are otherwise difficult to reach and require hand sanding. Depending on the task, you may grip the rear handle alone, or the rear handle and the top of the ergonomically contoured soft grip motor housing, which is designed for this purpose. Profiles and grooves may be finished using the tip or edge of the selected accessory, which should occasionally be rotated during use to distribute the wear on the accessory and backing pad surface.

Always be certain that smaller workpieces are securely fastened to a bench or other support. Larger panels may be held in place by hand on a bench or sawhorses.

SANDING: Open-coat aluminum oxide sanding sheets are recommended for most wood or metal sanding applications, as this synthetic material cuts quickly and wears well. Some applications, such as metal finishing or cleaning, require special abrasive pads which are available from your dealer. For best results, use Bosch sanding and polishing accessories which are of superior quality and are carefully selected to produce professional quality results with your sander.

The following suggestions may be used as a general guide for abrasive selection, but the best results will be obtained by sanding a test sample of the workpiece first.

-7-