Bosch Power Tools 23612, 23609, 22612, 23614 Attaching Gear BOX Cover, Models 22618 & 23618 only

BM 2609140358 12-05 12/6/05 3:28 PM Page 11

The optional belt clip accessory will allow you to conveniently attach your tool to your belt. This feature will allow you to have both hands free when climbing a ladder or moving to another work area.

The belt clip can be attached to either side of the tool by securing it with a mounting screw. Always make sure you securely tighten the mounting screw before use.

To open clip, squeeze both release buttons and the clip will spring up automatically (Fig. 4). To use clip, turn tool upside down and attach to your belt.

To retract clip when not in use, push down on clip until it locks in the closed position.

CLIP

FIG. 4

RELEASE

BUTTONS

SWIVEL LIGHTING SYSTEM FIG. 5

Your tool is equipped with integrated light source in the knurled thumbwheel. The light will go ON as soon as you squeeze trigger switch, unless the thumbwheel is in the 0 position (Fig. 5).

The light beam can be adjusted to 3 positions in front of the chuck for the desired bit being used.

Position 1: The	focus	of	the	beam	is
approximately 20 mm.
Position 2: The	focus	of	the	beam	is
approximately 150 mm.
Position 3: The	focus	of	the	beam	is
approximately 500 mm.

Position 0: The beam is shut off permanently.

ATTACHING GEAR BOX COVER

(Models 22618 & 23618 only)

1.Remove rubber guard by pulling forward (Fig. 6).

FIG. 6 FIG. 7

2.Slide gear box cover into place (Fig. 7).

3.Replace rubber guard to secure gear box cover (Fig. 8).

FIG. 8 FIG. 9

RUBBER	GEAR BOX	RUBBER
GUARD	COVER	GUARD

-11-