Bosch Power Tools CLPK31-120, CLPK33-120LP Important Safety Instructions, Or Injury To Persions

! WARNING

BM 2610022016 04-12_BM 2610022016 04-12 4/17/12 11:21 AM Page 2

IMPORTANT SAFETY INSTRUCTIONS

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSIONS

This Flashlight is intended for Household use only.

WARNING- When using electric appliance, basic precautions should always be followed, Including the following:

-Read all instruction before using the appliance.

-To reduce the risk of injury, close supervision is necessary when an appliance is used near children.

-Use only the charger supplied by the manufacturer to recharge.

-Do not use outdoors.

-To reduce the risk of electrical shock, do not put the unit in water or other liquid. Do not place or store unit where it can fall or be pulled into a tub or sink.

Please read these instructions carefully before operation in order to use the Flashlight effectively and obtain maximum performance. Please keep these instructions for future reference.

1.Follow all operating and safety procedures attached to the charger and battery pack.

2.Use only Bosch battery pack catalog number BAT411.

3.Do not wash the Flashlight with water nor keep in a damp location. If the Flashlight gets wet, dry it off as soon as possible.

4.The Flashlight is ruggedly constructed. It should, however, be handled with care. Do not disassemble or forcibly pivot head beyond it’s stopping point.

!WARNING To reduce the risk of electric shock, disconnect

battery pack before cleaning or servicing.

INSERTING AND RELEASING

BATTERY PACK

To insert battery, align battery and slide battery pack into tool until it locks into position. Do not force.

Release battery pack from tool by pressing on both sides of the battery release tabs and pull downward (Fig. 1).

OPERATION

1.To turn the Flashlight "ON", squeeze and release trigger switch. To turn Flashlight "OFF", squeeze and release trigger switch (Fig. 1).

2.Your Flashlight has a articulating head that can be pivoted to desired position. To change the position of the head, pivot clockwise until it stops. To return head to it’s original position, pivot the head counter-clockwise until it stops (Fig. 1).

USER-MAINTENANCE INSTRUCTION Always remove the battery pack from handle base

before changing the bulb.

! WARNING All repairs, electrical or mechanical, should be

attempted only by trained repairmen. Contact the nearest Bosch Factory Service Center, Authorized Service Station or other competent repair service.

5.Check the charge level at least once a month, especially if used for emergency purposes (for example: in your car). If the light seems dimmer, recharge the battery pack.

INSTALLATION INSTRUCTIONS

To Reduce the Risk of Electric Shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

1.Rotate lens cap counter clockwise and carefully remove lens cap (Fig. 1).

2.Remove bulb from spring.

3.Reinstall replacement bulb in spring.

4.Reinstall lens cap and rotate clockwise to tighten.

5.Use only 10.8V, .65A bulb part number 2610951871 provided by a Bosch Factory Service Center.

Note: One replacement bulb is provided in the bulb storage compartment. To remove spare bulb, rotate cap counter-clockwise with a dime or a flat tip screwdriver to expose bulb.

-2-