BM 2610032211
Assembly
Disconnect battery pack from tool before making any assembly, adjustments or changing
accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
INSERTING BITS
Move reverse switch lever to the center “OFF” position. Remove battery pack and rotate the clutch ring to the drill bit symbol
“
”. Rotate the chuck sleeve counter- clockwise viewing from chuck end, and open chuck to approximate drill bit diameter. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Close chuck by rotating the chuck sleeve clockwise and securely tighten by hand (Fig. 2).
Do not use the power of ! WARNING the drill while grasping
chuck to loosen or tighten bit. Friction burn or hand injury is possible if attempting to grasp the spinning chuck.
FIG. 2
CHUCK SLEEVE
DRILL BIT
BIT HOLDER
SCREWDRIVER BIT
BELT CLIP
When the tool is attached to ! WARNING the belt, position yourself to
avoid entanglement with surrounding objects. Unexpected entanglement could cause the tool to fall resulting in injury to the operator or bystanders.
The belt clip accessory will allow you to conveniently attach your tool to your belt. This feature will allow you to have both hands free when climbing a ladder or moving to another work area.
The belt clip can be attached to either side of the tool by securing it with a mounting screw. Always make sure you securely tighten the mounting screw before use (Fig. 3).
To use clip, turn tool upside down and attach to your belt.
FIG. 3
4X BIT TIP HOLDER
Store only bit tips in the on- ! WARNING tool bit holder. Longer bits
could interfere with proper tool operation and result in user injury.
The four piece bit tip holder can be used for convenient on tool storage of your most commonly used bits.
When mounting bit holder accessory, mount on the side of the drill opposite the belt clip.
Always make sure you securely tighten the mounting screw before use. (Fig. 4).
FIG. 4 |
BIT HOLDER |
BELT CLIP
