BM 2610019017
FIG. 5
SPINDLE
FELT
POLISHING
DISC
and securely tighten an
TO REMOVE: Reverse procedure.
FIG. 6
SPINDLE
BACKING PAD AND SANDING DISC
!WARNING Before attaching a backing pad be sure its maximum safe
operating speed is not exceeded by the nameplate speed of the tool.
Place the rubber backing pad onto the spindle shaft. Center the sanding disc on top of the backing pad. Insert the lock nut through the disc and thread onto the spindle as far as you can with your fingers. Press in the spindle lock, then tighten the backing pad securely with spanner wrench (Fig. 6).
WIRE CUP BRUSHES
!WARNING Before attaching a wire brush be sure its maximum
safe operating speed is not exceeded by the nameplate speed of the tool.
Wire brushes are equipped with their own threaded hub, simply thread on to spindle
FIG. 7
SPINDLE
RUBBER
BACKING PAD
SANDING
DISC
LOCK NUT
WIRE CUP
BRUSH
Operating Instructions
"TRI-CONTROL" PADDLE SWITCH
The
TO UNLOCK SWITCH AND TURN TOOL "ON": Push paddle lever FORWARD (toward the spindle) then squeeze the paddle lever.
TO SWITCH TOOL "OFF": Release pressure on paddle lever. The switch is spring loaded and will return to "OFF" position automatically.
The
TO LOCK SWITCH "ON": After paddle switch has been activated push paddle lever completely FORWARD and release paddle lever.
TO SWITCH TOOL "OFF": Squeeze and then release paddle lever. The switch is spring loaded and will return to "OFF" position automatically.
| Hold the tool with both | |
! WARNING | ||
hands while starting the tool, |
since torque from the motor can cause the tool to twist.
