![](/images/new-backgrounds/1214277/21427719x1.webp)
BM 2610034449
Note: The deluxe fence must be attached to the left side of the tool. (Fig. 1).
Installing the deluxe guide fence: Place the wing knob through the appropriate hole in the guide bracket and screw into left side of the housing. Securely tighten wing knob. Setting the cutting width: Place wing knob through the left fence arm and slide along the guide bracket to the desired position. Securely tighten wing knob. Be certain that the flat washer (supplied) is fitted between the bottom of the guide fence and wing knob or the guide fence is likely to slip.
Setting the cutting width: Loosen wing knob and using the width scale, slide the fence along the guide bracket to the desired position. Securely tighten wing knob (Fig. 1).
Setting the cutting angle: Loosen round knobs and pivot the fence to the desired position. Securely tighten round knobs (Fig. 1).
Note that the adjustable front shoe contains
achamfer
RABBETING DEPTH STOP
The optional rabbeting depth stop accessory (Fig. 1) allows the user to set any rabbeting depth from 0 to 5/16 inch. For best results, it is important that the blade be properly aligned (See "BLADE ALIGNMENT"). The width of the rabbet is controlled by the width fence. The maximum cutting width is
Setting the rabbet depth: Loosen wing knob and using the depth scale on the rabbeting depth stop, set the desired rabbet depth. Securely tighten wing knob.
FIG. 6 | FIG. 7 |
8 mm max
82 | mm |
| |
max |
INSERTING AND RELEASING | FIG. 8 |
BATTERy PACK |
|
To insert battery, slide charged battery pack into the housing until the battery pack locks into position.
To remove the battery pack, press the battery pack release button and slide the battery pack forward (Fig. 8).
45°
BATTERY
PACK
RELEASE
BUTTON
BATTERY
PACK