BM 2610000813
FORWARD/REVERSING |
| |
FIG. 5 | ||
LEVER & TRIGGER LOCK |
!WARNING After tool use, lock trigger in “OFF” position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/ reversing lever and trigger lock located above the trigger (Fig. 5). This lever was designed for changing rotation of the bit, and for locking the trigger in an “OFF” position.
For forward rotation, (with chuck pointed away from you) move the lever to the far left.
For reverse rotation move the lever to the far right. To activate trigger lock move lever to the center off position.
! | CAUTION | Do not change direction of | |
rotation until the tool | |||
|
|
comes to a complete stop. Shifting during rotation of the chuck can cause damage to the tool.
GEAR SHIFTING | This is especially useful in the repetitive | |
Your tool is equipped with two separate gear | driving and removal of screws. | |
ranges, low gear and high gear. Low gear | BUILT IN WORK LIGHT | |
provides | ||
Your tool is also equipped with a light that turns | ||
speeds for heavy duty work or for driving | ||
on automatically when the switch is activated, | ||
screws. High gear provides faster speeds for | ||
for better visibility when drilling/driving (Fig. 6). | ||
drilling lighter work. To change speeds slide | ||
| ||
switch, to the high or low position (Fig. 6). | FIG. 6 | |
ATTENTION: If your tool appears to be | ||
GEAR SHIFTER | ||
running, but the chuck will not turn, check to |
| |
make sure the gear shifting switch is pushed | ADJUSTABLE | |
fully into desired setting. | ||
| CLUTCH |
ADJUSTABLE CLUTCH
Your tool features 21 clutch settings. Output torque will increase as the clutch ring, is
rotated from 1 to 20. The drill “
” position will lock up the clutch to permit drilling and driving heavyduty work, and also enables bits to be changed quickly and easily in the keyless chuck (Fig. 6).
BRAKE
BUILT IN
When the trigger switch is released itWORK LIGHT activates the brake to stop the chuck quickly.
