BM 160992A0H1 01-14_RH745 RH850VC 1/22/14 10:22 AM Page 8
Assembly
INSTALLING ACCESSORIES | FIG. 2 |
Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant.
Insert accessory into the tool holder through the dust shield, while twisting and pushing inward until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the tool holder (Fig. 2).
NOTE: The high efficiency available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The "cost" to maintain sharp and undamaged accessories is more than offset by the "time saved" in operating the tool with sharp
accessories. |
|
| ||
| REMOVING ACCESSORIES | DUST SHIELD | ||
! | WARNING | Accessories may be hot after | ||
| ||||
|
| use. Avoid contact with skin |
| |
and use proper protective gloves or cloth to remove.
To remove an accessory, pull and hold locking sleeve backward and pull bit forward (Fig. 2). All accessories should be wiped clean after removing.
LOCKING SLEEVE
AUxILIARy HANDLE |
|
FIG. 3 | |
The tool must be supported with the auxiliary |
|
handle, which can be swiveled 360˚. To |
|
reposition and/or swivel the handle, loosen |
|
the hand grip, move the handle to the |
|
desired position along the barrel and |
|
securely retighten the hand grip (Fig. 3). |
|
HAND GRIP
