VDN-240 / VDC-240 / VDI-240 - Quick Install
1/2
1
VDN(C)-240 VDI-240
4x Anchors
Guide pattern
GUIDE PATTERN | GUIDE PATTERN |
Rubber pad
Conduit cap
Dome base
4x screws
Dome cover
Wrench
Service cable
1 Safety
1.1Safety precautions
DANGER!
High risk: This symbol indicates an imminently hazardous situation such as "Dangerous Voltage" inside the product. If not avoided, this will result in an electrical shock, serious
bodily injury, or death.
WARNING!
Medium risk: Indicates a potentially hazardous situation.
If not avoided, this could result in minor or moderate bodily injury.
CAUTION!
Low risk: Indicates a potentially hazardous situation.
If not avoided, this could result in property damage or risk of damage to the unit.
CAUTION!
The Low Voltage power supply unit must comply with EN60950
/UL60065. The power supply must be a
CAUTION!
Installation should only be performed by qualified service personnel in accordance with the National Electrical Code or applicable local codes.
2
DOWN
Pan
Tilt
Twist
Zoom
Focus
1.2Important safety instructions
1.Read these instructions.
2.Keep these instructions.
3.Heed all warnings.
4.Follow all instructions
5.Do not use this apparatus near water.
6.Clean only with a dry cloth.
7.Install in accordance with the manufacturer's instructions.
8.Do not install unit near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
10.Only use attachments/accessories specified by the manufacturer.
11.Unplug this apparatus during lightning storms or when unused for long periods of time.
12.Refer all servicing to service personnel. Servicing is required when the apparatus has been damaged in any way, such as
3
DOWN
| Pan |
Twist |
|
Tilt | Zoom |
Focus |
|
| IR LEDs |
1.3FCC & ICES compliance
FCC & ICES Information
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–reorient or relocate the receiving antenna;
–increase the separation between the equipment and receiver;
–connect the equipment into an outlet on a circuit different from that to which the receiver is connected;
–consult the dealer or an experienced radio/TV technician for help.
Intentional or unintentional modifications, not expressly approved by the party responsible for compliance, shall not be made. Any such modifications could void the user's authority to operate the equipment. If necessary, the user should consult the dealer or an experienced radio/television technician for corrective action.
4
Video
GND
BNC female
1 Vpp |
|
75 Ohm | 24 VAC / 12 VDC |
| Class 2 |
Menu (set)
DOWN
1.4Bosch notices
Disposal - Your Bosch product was developed and manufactured with
Optical elements
Optical elements are sensitive and should be protected at all times. Do not allow objects to come into contact with glass surfaces and do not touch optical elements with your fingers.
Copyright
This manual is the intellectual property of Bosch Security Systems and is protected by copyright.
All rights reserved.
Trademarks
All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly.
Note
Bosch Security Systems accepts no liability for damage resulting directly or indirectly from faults, incompleteness or discrepancies between the user guide and the product described.
More information
For more information please contact the nearest Bosch Security Systems location or visit www.boschsecurity.com