Bose manual Check the connections, Plug in the Powered Acoustimass Module

Setting Up

Check the connections

Figure 6

Completed connections

Figure 7

Turn on the Powered Acousti- mass module

Check all connections from the receiver to the Powered Acoustimass module and from the module to the cube arrays (Figure 6). Make sure all cube arrays are connected to the proper terminals according to their position in your room. Check that all wires are connected in phase (+ to + and – to –). Incorrect wiring can result in a total loss of module output. Correct wiring problems before you plug your receiver in and turn it on.

FRONT SPEAKE

R

FRONT SPEAKERS		SURROUND SPEAKERS	LFE/SUBWOOFER
R	L	R REAR L CENTER	OUT

Plug in the Powered Acoustimass Module

When you have checked all connections, plug in the power cord of the Powered Acousti- mass module. Be sure to turn the power switch on (Figure 7). It is not necessary to turn the module off after each use. The speaker system turns on and off automatically as it receives a signal from the receiver. Turn the system off at the receiver.

AM194452_06_V.pdf October 22, 2001 9