Bose CCM-003041 Setting your digital surround sound receiver, Receiving a digital audio signal

Français Español

USING YOUR SYSTEM

English

Setting your digital surround sound receiver

Figure 10

Digital signal receiver connections

Speakers in your Bose® Acoustimass® 16 Series II or Acoustimass 15 Series III system are fully compatible with the audio output of digital surround receivers. The system’s integrated signal processing supports full low-frequency reproduction from all channels.

To gain complete advantage of these system capabilities, you may want to adjust some! settings on your receiver. To make changes, use the digital display menu on the receiver and refer to the list of recommended settings, below.

Speaker		Receiver setting
•	Left and right	LARGE
•	Center	LARGE
• Left and right surround		LARGE
•	Center surround*	LARGE
•	LFE/Subwoofer	ON

* With an Acoustimass 16 Series II system or upgraded Acoustimass 15 Series IlI system only.

Note: If your receiver provides it, the LFE or Subwoofer option setting should be ON and the crossover value at the lowest number possible, which is typically 80 Hz.

Receiving a digital audio signal

For the digital audio signal from your DVD player to reach your surround receiver, you need a digital audio connection between the DVD player and receiver (Figure 10).

1.Use either the Optical or Coaxial input (not both) on the receiver to connect to the digital output from the DVD.

2.Be sure to select the digital output in the setup menu of your DVD player.

For additional setup and operating information, please refer to the owner’s guide that came with your surround receiver.

Use one or the other,

NOT both

Setting your analog surround sound receiver

For analog (non-digital) surround sound applications, we recommend that you set the ! surround sound center mode of your receiver to Wide. For instructions on how to change this setting, refer to the owner’s guide provided with your surround receiver.

12