3. INSTALLATION
Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly.
Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
If installation angle exceeds 30° from horizontal, the unit might not give its optimum
performance. | 30° |
|
Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive vibration.
Be sure to remove the front panel before installing the unit.
DIN FRONT/REAR-MOUNT
This unit can be property installed either from “Front” (conventional DIN
-DIN FRONT-MOUNT (Method A) Installation the unit
1
|
| 2 |
| 182 |
|
53 | 3 | 4 |
|
|
16
7
4
25
3
1.Dashboard
2.Half Sleeve
After inserting the half sleeve into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place.
3.Screw
4.Remove the two screws that fix the CD deck mechanism player before mounting the unit.
1.Dashboard
2.Nut (5mm)
3.Spring washer
4.Screw (4x12mm)
5.Screw
6.Support Strap
Be sure to use the support strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle.
7.Plain washer
E - 2
